Dynamic Stability Control MK60 for E87

The E87 is equipped with Dynamic Stability Control MK60. The DSC MK60 in the E87 corresponds to the fundamental principle of the DSC MK60 in the E85.

Functional description, see BMW Technology:

TIS -> Document -> SI Technology -> Enter SBT Number

SBT number:

Diagnosis instructions

An internal brake pressure sensor replaces the two brake pressure sensors on the main brake cylinder. This brake pressure sensor cannot be replaced separately.

The hardware and software of the control module have been adapted to the vehicle circuit structure.

The software of the control module can be updated when required by authorized dealerships in compliance with strict security and procedure rules.

For Condition Based Service, the brake lining wear is determined by the DSC control module. The brake pad wear sensor are therefore designed in two stages.

Faults in the Steering Column Switching Center (SZL) are sent across the F-CAN to the DSC and stored in the DSC control module.

The control-module functions for the SZL can be called up via the DSC control module.

Sequence for replacement of DSC module or DSC control module

After replacement of the DSC module or of the DSC control module, the following work is to be performed in the following order:

  1. Coding DSC
    On code the DSC, vehicle-specific data records are selected (e.g. size of the brakes). At the same time, the data for coding for the steering column switching center is stored and transferred across the F-CAN to the SZL. This means that if the SZL is replaced the DSC control module also has to be coded (as of 12/04). Without successful coding, no calibration of the steering-angle sensor is possible.
    Even if there are faults in the DSC, coding is normally possible.
  2. Calibration of steering-angle sensor
    The zero point of the steering-angle sensor, the vehicle identification number and the serial number of the SZL are stored.
  3. Calibration of DSC unit
    The internal brake pressure sensor is calibrated.
    There must not be any faults that concern the brake pressure sensor.
  4. Venting routine for DSC unit
  5. Check for swapped brake lines
  6. Initialize Run Flat Indicator (see owner's manual)

Sequence for replacement of the DSC sensor

After replacement of the DSC sensor, the service function ”Calibration DSC sensor” must be run. The lateral-acceleration sensor is calibrated in the DSC sensor.

Notes on the steering-angle sensor

The steering-angle sensor forms a unit with the steering column switching center. It cannot be replaced alone. The service function ”Calibration of steering-angle sensor” must be run after the following work: