enables balancing of the run-time-dependent changes to the injector rates. This improves the emissions values.
As of a certain kilometer reading and with the engine idle speed, the DDE control module learns the deviation of the injection rate of all four injectors on the basis of a number of injection parameters. This deviation is then corrected by the DDE control module.
Fuel Delivery Drift Calibration only influences the amount of the pre-injection.
Dependent of the repair, the service function Fuel Delivery Drift Calibration must be run in the event of repairs. This is the only way to ensure that the calibration works after the repair.
The following table shows the operation to be run in the service function depending on the repair:
Repair |
Operation service function |
Replacement of the DDE control module, all injectors old |
|
Engine replacement |
|
Replacement of all injectors, DDE control module old |
|
Replacement of the DDE control module, maximum three injectors replaced |
|