Retainer of front roof shell towards middle roof shell

Adjusting the retainer of front roof shell towards middle roof shell

• Check the position of the locking pins in the retainer for the front roof shell: see Fig. 1. The locking pin must not protrude from the retainer.
  If the protrusion is too small or if the locking pin even protrudes, continue with point 2.
  

• Remove the headlining of the front roof shell.
  

• Mark the position of the retainer in the roof shell with a felt pen.
  

• Remove the three mounting bolts of the retainer. See Fig. 2.
  Important: the height position of the detent specified by barrel bolts must not be changed!
  

• Remove the retainer and the clips of the guide pipe.
  

• Loosen the Torx screws (E) at the retainer. See Fig. 2.
  

• Turning the retainer moves the locking pin in relation to the housing. In this case, turn the retainer 1-2 revolutions so that the locking pin moves further into the retainer.
  

• Retighten the Torx screws at the retainer.
  

• Close the roof and observe the movement of the retainer. Reopen the roof gradually until the retainer can only just be moved.
  

• Bring the retainer to the marked position and only secure with the front bolt (C). See Fig. 2.
  

• Fully close the roof and secure the rear bolt (B). See Fig. 2.
  

• Move the roof into the intermediate position and secure the side bolt (D). See Fig. 2.
  

• Reinstall the headlining.
  

Fig. 1

Locking pins

Fig. 2

(A) Retainer for front roof shell

(B) Front Torx screws

(C) Rear Torx screws

(D) Side Torx screws

(E) Side Torx screw

Fig. 3

To adjust, turn the front roof shell retainer to the left or right.