The tyre defect indicator (RPA) is designed to monitor the tyre status while driving. The ABS wheel speed sensors monitor the four wheel speeds independently of one another. The control unit evaluates the speed signals from the ABS and makes the corresponding information available to the driver as required, thus informing the driver of a possible tyre defect.
Tyre defect indicator (RPA)
For vehicles up to model year 03/2002:
The control unit is a microprocessor-controlled system. It is supplied and activated via terminal 15. The control unit is located in the luggage compartment behind the side panelling on the right-hand side.
For vehicles as of model year 03/2002:
The tyre defect indicator function is integrated in the ABS/ASC+T/DSC control unit.
The calibration button is located at the end face of the storage tray between the seats.
Already fitted.
The wiring harness is equipped with an 18-pin connector that contains all the supply, signal and bus leads for the RPA (tyre defect indicator) control unit.
The system is designed to monitor the tyre status while driving. Loss of pressure in a tyre reduces the rolling circumference of the wheel. This increases the rotation speed of this wheel. The tyre defect indicator measures the wheel speeds and sets up a comparison of the diagonally opposed wheels and the average speed, thus detecting air-pressure loss. In this context, extreme driving situations such as strong acceleration or fast cornering are detected and corrected by the software. The system provides information as of 15 km/h minimum speed. The ABS speed sensors determine the wheel-speed signals and send them via the DSC control unit to the RPA control unit. The tyre pressure to be monitored is specified by the driver. Using the calibration button, the driver instructs the system to adopt the current set of wheels with the selected tyre pressure as the setpoint pressure. Within the framework of the calibration process, the system automatically learns the tyre reference status. Depending on driving style and conditions, the learning process can take between 45 minutes and several hours. However, the system is already armed for warnings after 10 minutes and can detect air-pressure losses of 50%. As the calibration continues, the warning thresholds are increased to 30% ± 10% of the cold air pressure. The instrument cluster informs the driver about the operating status of the tyre defect indicator.
The system has discovered a flattening of a tyre. The flattening lies above the defined limit values (see function).
A system malfunction detected by the RPA control unit.
The calibration procedure has been triggered. Pressing the calibration button for six seconds starts the calibration procedure. Here, the ignition must be on and the engine off.
Calibration must be performed every time the cold air pressure, the wheel position or the set of wheels are changed. If this is not the case, a false alarm can occur.